By-Pass Sizing Calculator

Often with zoning systems a By-Pass is needed to relieve excess air when only a small zone or number of small zones cannot deliver the required air flow thru the HVAC System. A by-pass is often ducted back into the return air or into non-critical, common conditioned temperature areas such as entry ways, hallways, basements, etc.

Select your Maximum Total System Cubic Feet per Minute (CFM), then enter the CFM of your Smallest Zone to calculate the type of By-Pass Damper you require.

Note: If the By-Pass CFM amount is 30% or less of the Total System CFM, No By-Pass is required.

Loading...


SPRD08

The By-Pass Damper you are looking for is SPRD08.

Check it out here.

SPRD09

The By-Pass Damper you are looking for is SPRD09.

Check it out here.

SPRD10

The By-Pass Damper you are looking for is SPRD10.

Check it out here.

SPRD12

The By-Pass Damper you are looking for is SPRD12.

Check it out here.

SPRD14

The By-Pass Damper you are looking for is SPRD14.

Check it out here.

SPRD16

The By-Pass Damper you are looking for is SPRD16.

Check it out here.

RDM18-SPC

The By-Pass Damper you are looking for is RDM18 w/SPC.

Check it out here.

RDM20-SPC

The By-Pass Damper you are looking for is RDM20 w/SPC.

Check it out here.

ZDSM2020-SPC

The By-Pass Damper you are looking for is ZDSM2020 w/SPC.

Check it out here.

ZDSM2420-SPC

The By-Pass Damper you are looking for is ZDSM2420 w/SPC.

Check it out here.

ZDSM3024-SPC

The By-Pass Damper you are looking for is ZDSM3024 w/SPC.

Check it out here.

$0

RDL – Round Damper Spring Return


Description

The RDL series are galvanized steel, single blade dampers compete with a 120 Volt, spring return motor actuator. These dampers are shipped complete and ready for installation. The RDL can be installed in any position in any properly sized duct. All RDL dampers are rated for duct systems less than 1.0” W.C. The RDL has a gasket seal that ensures a tight shut off when the damper is closed.

Dampers are available in 4” 5”, 6”, 7”, 8”, 9”, 10”, 12”, 14”, 16”, 18” and 20” diameters. Dampers are ordered as RDLdd, using 2 digits for each dimension.

RDL Operating & Installation Instructions